Article Ideal Water Parameters

Below are recommended water parameters that can be used as a guideline for general marine tanks.

pH - 8.2 to 8.4
Salinity - 30.5 to 35 (or 1.023 to 1.026 Specific Gravity (SG))

Calcium - 380-420
Alkalinity - 6 to 9 dKh (ideally 6.5 to 8.5 dKH) NSW levels
Magnesium - 1300 to 1350
Iodine - 0.04 to 0.06
Strontium - 8ppm or 8mg/l (NSW levels)
Potassium (K+) - 380-420
Nitrite - 0
Nitrate - less than 5
Phosphate - less than 0.01
Ammonia - 0

Calcium (Ca)

All calcareous animals, especially corals need calcium and carbonates to grow and flourish. However the growth rate of corals depends mostly on the zooxanthellae (algae) that live symbiotically within them. These algae present the coral with precious carbohydrates of their own metabolism. As they photosynthesize, they use carbon dioxide from the water, which enables the coral to precipitate calcium carbonate in its skeleton.

Natural sea water contains on average 400-410 ppm of calcium and is typically saturated at this level. It is important not to exceed 450 ppm, as super saturation can result in the calcium surplus precipitating out of the solution, taking desirable trace elements with it (commonly known as a snowstorm in a tank).

Alkalinity (KH or dKH)

Natural alkalinity and calcium concentrations are of special importance to ensure optimum growth and well-being of many invertebrates and calcareous algae in an aquarium. In many reef aquaria an increase of alkalinity and a decrease of calcium often occur.

Magnesium (Mg)

A sufficient supply of magnesium is as essential for the growth and well being of reef building coralline algae as calcium. It is one of the major constituents of seawater and is directly involved in algae photosynthesis, i.e. the conversion of carbon dioxide (CO2) and light into organic compounds. Magnesium helps in the calcification process of invertebrates and is essential to balance KH and Ca.

Iodine

Of all the trace elements found in natural sea water, iodine is associated with the widest range of effects. Iodine prevents goitre as an important component of the thyroid hormone. It also is essential for the hardening of the chitinous shell of crustaceans. Corallinaceous red algae deposit iodine in surface structures and gorgonias deposit it in the axial skeleton.
Experiments clearly show that idoine improves the adaptation to light and the colouring of anthozoa, especially of hard corals.

Due to its unstable nature in solution, iodine should be added to a marine aquarium on a regular basis in its most effective form, as elementary I2. Iodine demand increases with aquarium population density.

Strontium

A sufficient supply of strontium and carbon dioxide is as essential for the growth and well-being of reef-building corals as calcium. Both elements are supplied to the corals with the help of the zooxanthellae (algae) that live symbiotically within them.

Ammonia (NH3)

Ammonia Nitrogen, the first toxic stage of the nitrogen cycle.

Nitrite (NO2)

An Unstable form of nitrogen and the second stage of the nitrogen cycle.

Nitrate (NO3)

The final part of the nitrogen cycle which denitrifies in anoxic conditions and turns into nitrogen gas.

Phosphate (PO4)

An unwanted nutrient found in tap water, fish foods etc that feeds slime and hair algaes.
 
Last edited:
OK so was looking at our "ideal" parameters and was thinking since I'm in the security industry what electronic alarms are available .. I know of something for high/low temp and maybe high/low levels .... Any other "sensors" I can can hunting for and then incorperate it into a sms notification unit.......
 
OK so was looking at our "ideal" parameters and was thinking since I'm in the security industry what electronic alarms are available .. I know of something for high/low temp and maybe high/low levels .... Any other "sensors" I can can hunting for and then incorperate it into a sms notification unit.......
Ph and redox.
 
Thanx Mek ... where can I get these sensors and do the sensors tell me if the ph is too high and too low and what do the redox sensor tell me.... Oh by the way are these normally open/normally close contacts?
 
1) Magnetic water flow switch/sensor so that you know that the filter return pump is working.
2) Light sensor so that light switching is indicated.
3) Water leak sensor to indicate floods/overflows.
4) low DO indicator.
5) High atmospheric CO2 switch.
6) Acoustic detector to hear what the LS are saying about you.

:)
 
Great ... Where do I start looking for these sensors .... Audio sensor wont work NJ .... going to use SMS module :razz::lol: ... Wait we could convert their gossip to text then sms it!
 
Below are recommended water parameters that can be used as a guideline for general marine tanks.

pH - 8.2 to 8.4
Salinity - 1.023 to 1.026 (or 30.5 to 34.5 Specific Gravity (SG))

Calcium - 380-420
Alkalinity - 6 to 9 dKh (ideally 6.5 to 8.5 dKH) NSW levels
Magnesium - 1300 to 1350
Iodine - 0.04 to 0.06
Strontium - 8ppm or 8mg/l (NSW levels)
Potassium (K+) - 380-420
Nitrite - 0
Nitrate - less than 5
Phosphate - less than 0.01
Ammonia - 0
When last have you tested our oceans salinity? I collected sea water last weekend & just checked it out of curiosity & it measured 1.016 10pm saterday night. So my question is why must our tanks salinity be so much higher than the oceans salinity as most of the fish we buy are wild caught?
 
Hi Makaeel,

What is the best testkit for saltwater ??
Hi Shaun! Tropic Marin, Elos, Deltec Lamoette are all god test kits hey. I have always use Topic Marin, and im pleased with it. But for P04, it is not accurate enough, rather go for Deltec on this one. :)

Thanx Mek ... where can I get these sensors and do the sensors tell me if the ph is too high and too low and what do the redox sensor tell me.... Oh by the way are these normally open/normally close contacts?
Contact lighty, he will sort you out with all this stuff.
When last have you tested our oceans salinity? I collected sea water last weekend & just checked it out of curiosity & it measured 1.016 10pm saterday night. So my question is why must our tanks salinity be so much higher than the oceans salinity as most of the fish we buy are wild caught?
Howzit dude? Where was the water collected from(river outlet or storm water outlets neaby), and did you use a hydrometer or a well calibrated refractrometer to test salinity?
 
Hi Shaun! Tropic Marin, Elos, Deltec Lamoette are all god test kits hey. I have always use Topic Marin, and im pleased with it. But for P04, it is not accurate enough, rather go for Deltec on this one. :)


Contact lighty, he will sort you out with all this stuff.

Howzit dude? Where was the water collected from(river outlet or storm water outlets neaby), and did you use a hydrometer or a well calibrated refractrometer to test salinity?

Hey mek ja I collected water from blouberg beach but went in waist deep to fill containers & used hydrometer.
 
And did you measure in the sea at waist deep?

And did you correct the hydrometer reading (SG) for temperature ?

The recommended salinity is based on thousands of reading taken over many years at hundreds of locations over the tropical reefs by scientists using very accurate equipment...

Hennie
 
And did you correct the hydrometer reading (SG) for temperature ?

The recommended salinity is based on thousands of reading taken over many years at hundreds of locations over the tropical reefs by scientists using very accurate equipment...

Hennie
And did you end up buying a refractrometer afterwards? :lol:
 
Here's i "fast" one

What are the advantages of running an SG higher then 1.023?
 
i'm running a ts1 on my 600L system with SG at 1.0225 and my skimmer is working lekke and i have no buildup of nutriance. Most retail shops run their tanks at 1.022, so i don't think it's worth putting the fish and corals thru that change of osmoses just so the skimmer can work better.:slayer:
 
Back
Top Bottom