Upgrade to RSM 250
- Thread starter Journeyman
- Start date
Hello @Journeyman, nice upgrades you are doing to the RSM 250.
I also have a RSM 250 and would just like to find out which return pumps you bought to replace the original return pumps and which hood cooling fans you bought to replace the original ones?
Links will be highly appreciated.
I also have a RSM 250 and would just like to find out which return pumps you bought to replace the original return pumps and which hood cooling fans you bought to replace the original ones?
Links will be highly appreciated.
Hi Wade.
The fans are from Micro Robotics
| Fan 60x60x20mm 12V - 300mm | FAN6020-L300-12V |
Micro Robotics- Centurion Stellenbosch - Arduino Importer
Micro Robotics, Importers, Arduino,Sensors, Robotics, Pololu, Adafruit, DF Robot, Raspberry Pi, Beaglebone Black, Teensy, Stepper Motor, South Africa
www.robotics.org.za
The return pumps I added are the DCS-3000(@ 4led speed) DCS-2000 (@3 led speed) both Jebao DC pumps got them on Takealot.The 2 fans on the back is thinner you will need to shop around for them.
Last edited:
An quick update - had a nasty bubble algae outbreak with the warm weather to the point of taking the rocks out and scrubbing them one by one today below after photo.
Last edited:
Just a quick update on the tank
Last edited:
Cleaning time, as a lot of coral growth can be noticed - holy-wood stunner especially.
Here is the current operational mode for my RSM 250
For cooling these fans on the back left are used
Also the small desk fan is used in summer, cooling at the back since I did not receive the lid to close the area with the tank
Here my ATO and skimmer hard at work below my Gravity ATO
The two Lancia wifi lights in the hood. (590 and 895) controlled from my mobile phone
The Tunze skimmer, ATO level control float and cope-pod hotel
The auto feeder
Then the only dosing I do are
For cooling these fans on the back left are used
Also the small desk fan is used in summer, cooling at the back since I did not receive the lid to close the area with the tank
Here my ATO and skimmer hard at work below my Gravity ATO
The two Lancia wifi lights in the hood. (590 and 895) controlled from my mobile phone
The Tunze skimmer, ATO level control float and cope-pod hotel
The auto feeder
Then the only dosing I do are
Last edited:
Update on the progress of the tank.
New corals added
New corals added
Last edited:
Any updates?
Been busy with work, but here is a status of the tank
Yes I caught it in time had a nitrate increase and currently slowly bringing it back down with carbon dosing ( Vinegar+ kalkwasser dosing) did lose a few corals but it is stable now. The algae is dying off as well as kept in check by the Urchin, snails and foxface.