Hi all, i have now experienced a problem with my Hailea 500A chiller. It had a gas leak which i got repaired. I never used it since i got it back from repairs. It was taken to Middelburg to repair so going back there is not really an option. Wha happens the moment i put the plug into a socket (plug has been checked and all wires are secure) is that it actually trip on my DB board. This shows that it has a big electrical problem. From what logic may tell me it could be getting wet somewhere iside and that's why it acts this way? Any electrical guys or DIY experts that could please assist in getting to the problem and getting it sorted?
[wtd] Hailea Chiller Electrical Help
- Thread starter Zandy
- Start date
@Zandy, although plug and wires intact, have you checked the cabling, maybe while in for repairs it could have got a kink in it or damaged to the point of entry into the chiller, sometimes cannot be seen from the outside. Could cause issues. Water is another problem i have experienced with my 150a haliea chiller
Last edited by a moderator:
Also on the right hand side at the bottom have you checked the fuse
On my nano tank, i sprung a lbad eak and water got to the back of the unit, thought i had dried everything but apparently not, and it kept on tripping the electricity. Opened the whole chiller up and dried everywhere especially by all wiring and all back to normal
If you need a sparky to check it out I am more than willing to assist.
I am qualified with wireman's licence.
Norman
I am qualified with wireman's licence.
Norman