[FS] Meanwell ldd drivers on PCB, led controller and power supple

Bigbone

Bigbone

Joined
3 Feb 2014
Posts
552
Reaction score
57
Location
Cape town
Selling my meanwell ldd drivers on PCB board and power supply and led controller.
Selling for 500 each or R1200 for all 3.
484c934adb79ee74c90e303051266df5.jpg
65b7b5e5c151f1952c9dd499aad0a494.jpg
bade8caaa2b7fa2eb95d33a350f3ca95.jpg
 
Hi sorry for the ignorance here, but what are the AGM-32460 boards used for?
 
it makes life so much easier...less soldering and also everything is neater...just slip in wire and tighten.
 
so does it reduce the 12v for the LED's or just maintain the current at 700ma?
 
my understanding of these is not that good as I bought it as plug and play. However, I am almost sure that through a controller, the current is varied at constant voltage.
 
how would/does it plug into the current system in sequence:

My thoughts: 1 - power supply to 2 - controller then to PCB?
 
that sounds about right. To be honest, I did not use these drivers on my unit. I used the drivers that came with it but it was giving problems so I bought these on ebay but I have since bought me the vertex illumina LEDs so now I have no use for them.
 
R500 excluding shipping and its yours. PM me your number if you taking it.
 
@Bigbone. is the meanwell ldd drivers on PCB board still available? does the PCB have the 10k pull down resitors on it? Maybe a pic of the under side. thanks
 
Yip still available. See pic as requested
892303d1324e38218d8c3f1838691f93.jpg
 
You must log in or register to reply here.
Back
Top Bottom