AM Carx users advice

Mekaeel

Moderator
Joined
8 May 2007
Posts
24,226
Reaction score
131
Location
Point Waterfront Durban
Awrite crew.
I got myself a second hand AM KR1000 Carx (upgrading from the Reefoctopus Carx as it cannot meet my Bio load). I did however notice that the outlet (on the inside of the reactor) appears to be very shallow (if you get what I mean).
I've been thinking, would'nt this cause airblockages to the outlet?Therefore the reactor will require to be bleeded more often.
I was thinking about modifying it by extending the oulet deeper into the reactor, like 2cm or so. What would you guys suggest?
Oh yes. And i currently have the reactor with only 50% media in it +-4kg's need to get more.Can i run the reactor this way?

Thanks in advance :)
 
Joined
8 May 2007
Posts
2,420
Reaction score
25
Location
Durban
Correct. You should not be getting an airbubble at the top. If you are then cut the co2 supply. Not sure about the mod but it makes sense.
 
Joined
10 Jun 2007
Posts
1,783
Reaction score
10
Location
durban,kloof
i got the same one, havent done any mods. mines runs perfectly now, dont have a drip rate problem.
 

Top