Turbelle® nanostream® electronic 6055 and 6095 are speed-controlled pumps with a Turbelle® controller operating on safety extra-low voltage, to be employed ideally in every aquarium from 40 to >1,000 liters (10 to >265 USgal.) for simulation of lapping waves or tidal currents. They contain a microprocessor-controlled motor and a Turbelle® controller. The electronic motor adapts its speed automatically to the pump load and always seeks the best efficiency at the lowest possible consumption of energy. The pumps will be stopped immediately in case of blockage. After the blockage has been removed, the pumps will start up automatically after a delay of 20 seconds. The pump driver has been provided with a fish care function, which causes a revolution of the propeller every twenty seconds when the pump is at a standstill. It can be controlled by the Multicontroller / SmartController 7000.
WIDE FLOW
Flow rate: 2,000 to about 9,500 l/h (550 to about 2,500 USgal./h)
with Turbelle® controller
Energy consumption: 5 - 21 W
Power supply unit: 100-240V / 50-60Hz
Cable length: 3 m (118”)
Dimensions: ø70 mm (2.7”)
Output: ø50/10 mm (2/.4”)
Magnet Holder with Silence clamp up to a glass thickness of 15 mm (2/3”).
R5 279
For more info :
Click Here
- Low motor heat
- 3D adjustment
- Flow profile
- Controllable speed, wave simulation, tidal currents
- Includes magnet holder
- Includes silence clamp
- Propeller technology
Turbelle Nanostream 6095
For aquariums from 100 to 1,000 liters (25 to 265 USgal.).WIDE FLOW
Flow rate: 2,000 to about 9,500 l/h (550 to about 2,500 USgal./h)
with Turbelle® controller
Energy consumption: 5 - 21 W
Power supply unit: 100-240V / 50-60Hz
Cable length: 3 m (118”)
Dimensions: ø70 mm (2.7”)
Output: ø50/10 mm (2/.4”)
Magnet Holder with Silence clamp up to a glass thickness of 15 mm (2/3”).
R5 279
For more info :
Click Here
- Photo Requirements
-
- Photo's are of the ACTUAL livestock or hardware being advertised.
